Quantum Manual Tank Gauge PVC

The K33 ATEX is a mechanical flow meter suitable for the monitoring of diesel, gasoline and kerosene. For non-commercial use, the K33 ATEX meets the ATEX requirements for precise measurement of the quantity of Gasoline, kerosene and diesel dispensed in environments with a high risk of explosion.

The ATEX mechanical flow meter has a 3-digit partial indicator, and a 6 digit totaliser.

PRECISION AND QUALITY

The K33 ATEX mechanical flow meter for gasoline, kerosene and diesel has been designed to ensure precise measurement of the amount of fuel dispensed. Easy to calibrate and install, the K33 ATEX flow meter can monitor the quantity of fuel dispensed for a maximum flow rate of 20-120 l/min and with a maximum working pressure of the pump of 3.5 bar. In addition, it can guarantee a burst pressure of 28 bar with a metering accuracy of +/- 1%.

RELIABILITY

The K33 ATEX mechanical flow meter for gasoline, kerosene and diesel is suitable for application to pumps or gasoline dispensers and is suitable for those who are looking for a simple and economic product, without particular need for control over the fleet of vehicles. The K33 ATEX can be installed in any position on both rigid and flexible pipes, as well as directly on pumps or tanks. It can also be used by gravity, thanks to its low resistance to flow.

The K33 ATEX as an ATEX flow meter is included in group II, category 2 G IIB T=85°C (T6), and therefore it is suitable for working in areas classified as "1" and "2" according to directive 99/92/EC.

The Tanker Reeling Fuel Delivery Hose is designed for fitting onto domestic fuel oil tankers for the bulk delivery of kerosene and diesel fuels into a storage tank.

This fuel oil tanker hose is available in 61m assemblies with either M x M or M x F heavy duty brass couplings with aluminium hose clamps. It is also offered as an open ended coil should you wish to add your own hose fittings. Available upon special request is a 35mm OD version of this fuel dispensing hose.

The Camlock Female Coupler with Male Thread has either a 1” or 2” male BSPT hose connection, and a 1” or 2” female cam socket respectively. Cam and groove couplings are designed to quickly connect and disconnect hoses without the use of tools, and offer a leak proof seal.

This high quality diesel transfer pump from FMT Swiss AG is manufactured from shock resistant Die-cast aluminium with extremely small tolerances. The small tolerances of this pump allow for great suction & pressure performance.

Fitted with an on/off switch, integral bypass & siphon protection, this 12v transfer pump is designed for a long service life and is capable of a 3 metre suction.

Specification - 

60 Minute duty cycle (Under free discharge)

3 metre cable & clips

3/4" BSP Female Inlet / Outlet with 1" BSP Male adapters

Self Priming Vane Pump

35 Litres per minute maximum flow rate

Up to 1.6 bar discharge pressure

3 Metre maximum suction height

Suitable for Fuel oils & Diesel

12v DC

IP54 Safety rating

NBR 70 Seals

3 year warranty