3" Hytek Overfill Prevention Valve

The Stainless Steel Wafer Swing Check Valve is a cost effective non-return valve, which only allows flow in one direction. Designed to fit in between flanges, these swing check valves are a compact solution for installations where space is an issue.

These stainless steel wafer valves comprise of a stainless steel body, viton seals, seats and an o ring, and the smaller surface area make it a cost effective alternative to equivalent valves.

This Brass Solenoid Valve is a direct acting valve, meaning that no pressure needs to be applied to operate, for a range of fluids including fuels, oils and water. As a normally closed solenoid valve, until the valve is activated the fluid flow is shut off. When the electrical current that runs through the coil inside the valve is energised, the valve opens and allows the flow of liquid through the pipework.

This brass solenoid valve is therefore designed for applications where fluid only needs to be released on occasions, such as to feed a generator with diesel from the back up storage tank. It could also be wired into a pump ensuring that fuel only enters the pipework from the tank when the pump is turned on.

The Adam Pumps PA1 70 Diesel Transfer Pump is a low cost, high quality Fuel pump manufactured in Italy. Due to the design of this pump, it can replace similar types of pumps as the location of the Inlet/Outlet ports & Footprint of the pump are the same as many others. With a low noise output & a 66 Litre per minute maximum flow rate, the PA1 70 from Adam Pumps is an economical choice for diesel transfer.

Adam Pumps 230v PA1 70 Specification -

230v 50hz Pump

On / Off Switch

IP55 Weather Protection

2 Metre Power Cable

1" BSPP Female Inlet / Outlet

Duty Cycle: Continuous Duty

70 L/min maximum flow rate

Max pressure: 2 bar

Integral Bypass valve

-20/+50 °C maximum operating temperature

Suitable for Diesel Only

1 Year Warranty

The Hytek IBC Mounted AdBlue Transfer Pump kit, is supplied with all parts to enable quick and easy transfer of AdBlue from an IBC. Neatly fitted to a bracket, this pump kit comes fitted with an Automatic nozzle & Digital flow meter.

AdBlue Pump Kit Specification -

Self Priming Diaphragm AdBlue Transfer Pump with 1.8m power cable

230v

Bypass valve & On/Off switch

30 Litres per minute flow rate

20 minute maximum run time

+/- 1% Accuracy (Flow Meter)

6 Metre delivery hose

1.5m Suction hose with SEC connector

Automatic shut off nozzle with stainless spout

Integrated hose nozzle holder

2 Year warranty